Probably the most straightforward job of the paneling process because the panels just fitted. I did have to tidy them up with a file quite a bit, and where the holes were laser cut was pretty rubbish as well.
The biggest issue was removing the burnt on plastic from the laser cutting. I tried the gentle approach with a plastic scraper and some IPA (not beer.....), but because these will be hidden by carpet I got a scotch pad out and made short work of it. In any case, I can always polish if I decide to keep it bare.
Plenty of glue and clamps, cleco pins as I drilled the holes off e.t.c. Wiping up the glue immediately afterwards of course (the bloody stuff is very sticky).
Afterthoughts were mainly focused on whether my fat arse is going to fit in there OK...
No comments:
Post a Comment